|
XM Antenna Installation
X5world 
01-09-2006
|
|
|
Contributed by: P. White
Install of XM
Antenna in Spoiler
|
|
|
Tools Needed: T-27 Torx
bit or Screwdriver, BMW Wire Pulling Tool, Patience. Remove plastic housings
from connectors to pull through car.
|
|
|
My new baby. 2002
X5 3.0 with Sport, Premium, Rear Climate, Cold Weather, Xenon.
|
|
|
|
Terk TRK-SR2 with
cover removed. 11 Torx screws around the bottom.
|
|
|
|
Remove bottom
rubber gasket and gasket along wires as well. Leave tape intact.
|
|
|
|
Rear spoiler or
wind deflector.
|
|
|
|
2 screws each on
left and right.
|
|
|
|
Remove cover to
access 2nd screw on each side.
|
|
|
|
One screw in
middle. Put this one back first when reassembling.
|
|
|
|
|
Just lift off top
of spoiler.
|
|
|
|
View of inside of
spoiler. There is no room underneath this piece.
|
|
|
|
Run wires with
washer hose. Left side is better for me.
|
|
|
|
Unplug hose and
slide off grommet to run wires. It's on tight, but it will go.
|
|
|
|
Feed wires through
holes. Run wires through rubber connector.
|
|
|
|
Use BMW wire
pulling tool. Actually, it's a wire hanger.
|
|
|
|
Pull wires through
one at a time. Be patient and work it through.
|
|
|
|
Remove one screw
and unsnap left side rear trim. Feed wires through hole in pad.
|
|
|
|
Feed down behind
trim to left side compartment. Reassemble. You're done!
|
|
|
|
|
Featured Articles
|
|
|
|
|
Linear Mode
